Method Of Working And Finishing Work - Meister MSE800-1 Traduction Du Manuel D'utilisation Original

5454000-Saebelsaeg_man 03.12.14 08:23 Seite 53
Switching off
Release the On/Off switch (4) and wait
for the machine to come to a standstill.
Switching on continuous operation
Push the On/Off switch (4) as far as it
will go, press the locking button for
continuous operation (5) (Figure 1b) and
then release the On/Off switch (4).
The machine starts at the previously set
stroke rate.
Switch the machine off to change the
stroke rate using the adjusting wheel (3)
(Figure 1b).
Switching off continuous operation
Release lock by pressing the On/Off
switch (4). Release the On/Off switch (4)
and wait for the machine to come to a
standstill.
10 – Method of working and
finishing work
Adapt the saw blade and stroke rate to
the respective material being used.
Remove any foreign objects from the
work piece.
We recommend carrying out test cuts
on waste materials in order to determine
the machine settings required.
CAUTION! Observe the safety
instructions!
CAUTION! Before cutting, use a
clamping mechanism to prevent
the work piece from slipping!
When processing materials, pay
attention to maximum cutting depth
specifications!
Switch the machine on, and move it
towards the work piece to be
processed. Place the saw shoe (8) on
the surface of the work piece and saw
the material with even pressure and
feed. If the saw blade jams, turn the
machine off immediately. Use a suitable
tool to open up the cut a little and
remove the machine. When you have
finished working, switch off the machine
and only set it down when it has come
to a complete standstill.
CAUTION! After working with a
low stroke rate for a long period
of time, operate in idle at maximum
revolutions for about three minutes to
let the machine cool down! When
doing so, pay attention to ensure that
the machine and saw blade do not
cause risks.
CAUTION! When sawing metal,
steel in particular, take regular
cooling breaks for inserting the saw
blade or applying cutting grease on
the blade! This will increase the
durability and edge retention of the
blade considerably.
Sawing without pilot hole (Figure 4)
If you have to cut into the centre of the
work piece and it is not possible to drill
a hole: Release the saw shoe, push all
the way back and lock. With the saw
blade in a tipped machine position and
the machine running, carefully guide it
across the work piece (a). As soon as
the work piece has been sawn through,
continue working with the machine in
the normal position (b).
53