Yamaha YVC-1000 Guide De Référence Rapide page 4

29 Turn the volume down to the minimum level before starting
playback.
Failure to observe this will cause loud noises to be emitted that
may result in hearing impairment.
30 Ensure not to use the product anywhere it will be exposed to rapid
changes in the ambient temperature. Any rapid change in the
ambient temperature could result in condensation on the product,
which could then result in damage to the product. Ensure to leave
the product for a while until it has dried off with the power turned
off if any condensation has occurred.
31 Ensure not to connect any cables while the power is turned on.
Failure to observe this could result in damage to the product and
any connected equipment.
This unit is not disconnected from the AC power source as long as it is connected to the AC wall outlet, even if this unit
itself is turned off. This state is called the standby mode. In this state, this unit is designed to consume a very small quantity
of power.
WARNING
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
We, Revolabs, Inc. (UK), hereby declare that this unit is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.
Revolabs, Inc. (UK)
190, High Street, Tonbridge, Kent, TN9 1BE, UK.
Tel: +44-1732-366-535
■
For U.K. customers
If the socket outlets in the home are not suitable for the plug supplied with this appliance, it should be cut off and an
appropriate 3 pin plug fitted. For details, refer to the instructions described below.
Note
The plug severed from the mains lead must be destroyed, as a plug with bared flexible cord is hazardous if engaged in a live
socket outlet.
■
Special Instructions for U.K. Model
IMPORTANT
THE WIRES IN MAINS LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured BLACK. The wire which is
coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
Make sure that neither core is connected to the earth terminal of the three pin plug.
32 Ensure to earth any static electricity from your body or clothing
before touching the product. Failure to observe this could result in
damage to the product.
33 Route and connect the cables correctly.
If the cables are pulled or become caught on someone's leg, the
product or connected equipment could tip over or fall, thus
resulting in injury or damage to the product.
34 Before connecting external equipment, thoroughly read the
instruction manuals provided with the equipment and make
connections according to the instructions.
3