Operation - Bucket Head BH01000 Mode D'emploi

WARNING: To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice
important signs indicating abnormal operation such as loss of suction,
debris/liquid exiting exhaust, or abnormal motor noises. Immediately stop
using Vac if you notice these signs.
• Do not leave Vac plugged-in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vac in areas with flammable gases, vapors or explosive dust
in the air. Sparks inside the motor can ignite airborne flammables.
Flammable gases and vapors include: lighter fluid, solvent-type cleaners,
oil-based paints, gasoline,
alcohol, or aerosol sprays. Flammable dusts include: coal, magnesium,
aluminum, grain, or gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
WARNING: To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment.
Store indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Do not service Vac while it is plugged-in. If your Vac is not working as it
should, has missing parts, has been dropped, damaged, left outdoors, or
dropped into water, immediately call customer service at 1-800-469-4663.
• When using an extension cord, use only outdoor-rated cords that are in
good condition. Do not allow the connection to come into contact with
liquid.
Align the powerhead latches with the
bucket handle/bail. Press down firmly
over each latch to engage the latches
with the bucket.
After plugging the power cord into the
pushing the switch from position "O" to
wall receptacle, turn the unit "ON" by
position "I". The symbols used on the
switch are international symbols.

OPERATION

Powerhead
Latch (2)
Bucket
5
= OFF
To remove the power head from the
bucket, remove the hose from the
powerhead and rotate the bucket
handle/bail away from the power cord.
Slightly spread both latches away from
the bucket and lift the powerhead off.
To reduce the risk of tip-over when
carrying by the handle/bail, align the
Bucket Head ® latches above the bail
attach points and be sure the bail is
snapped into the retention grooves on
the latches.
"I" - "ON"
Position
= ON
"O" - "OFF"
Position