Canvas FHWS80031 Instructions D'assemblage page 11

20 Product No. 085-1573-8 | Model No. FHWS80031
Step 9
Tank / Gas Line Connection or Leak Test
1. Make 2-3 oz of leak detection solution by mixing one part liquid dishwashing
soap with three parts water.
2. Make sure control knob is in the "OFF" position.
3. Connect LP gas tank per "Installing LP Gas Tank" section.
4. Turn LP gas tank valve to "OPEN".
5. Spoon several drops of solution, or use a squirt bottle, at all "X" locations
(figure 1 and 2).
a. If any bubbles appear, turn LP gas tank valve to "CLOSED", reconnect
and re-test.
b. If you continue to see bubbles after several attempts, turn LP gas tank
valve to "CLOSED" and disconnect LP gas tank, per "Disconnecting LP Gas Tank".
Contact 1-888-670-6684 for assistance.
c. If no bubbles appear after one minute, turn LP gas tank valve to "CLOSED",
wipe away solution and proceed.
Figure 1
WARNING: Failure to inspect this
connection or not follow these instructions
could cause a fire or an explosion which
can cause death, serious bodily injury or
damage to property.
Step 10
Requires A
Remove burner lid (A) before lighting.
Figure 2
A
Step 11
Once the LP gas tank is installed, close the door.
21