Beko ATH7120 Manuel De L'utilisateur page 11

3 Operation instructions
Press the negative oxygen ion switch button (Fig. 7), the indicator lights and the humidifier starts to
release a lot of negative oxygen ion to improve the air quality so to benefit your health. (This function
is not available under the sleep mode.)
Press auto button (Fig. 8), the humidifier enters into the auto mode and the corresponding indicator
light turns on. To escape from this mode, press the rate adjusting button.
Fig. 5 Fig. 6 Fig. 7 Fig. 8
When the humidifier works normally with sufficient water in the reservoir, lift the reservoir, it enters
into the no-reservoir guard mode and stops spraying vapor to prevent spattering. If the reservoir is
not resumed in place within 15 seconds, it rings for 3 seconds and the indicator light blinks. In sleep
mode, there is no ring, but only the moon blinks. When the reservoir is put back in place, the humidifier
resumes normal operation in 3 seconds. However, if the reservoir is not in place for 1 minute, the
indicator light blinks, but in sleep mode, there is no ring but only the moon blinks, until the humidifier
turns itself off. If there is not sufficient water in the reservoir, it stops spraying and rings for 3
seconds and the indicator light blinks, but in sleep mode, there is no ring but only the moon blinks, as
a reminder of adding water. If no water is added in within 1 minute, the indicator light blinks, but in
sleep mode, there is no ring but only the moon blinks, until the humidifier turns itself off. When it is on
standby, all the buttons are not workable except the power switch button.
The soft water container supplied with the humidifier is ready for use when tightened to the reservoir
lid properly. After adding in water, tighten the lid of soft water container onto the opening of the
reservoir to the extent that there is no leakage. If too tight, it will make the loosening for the next
refilling more difficult. Sometimes, it leaks because the lid is so tight that the rubber insert is forced
out of place. In this case, loosen the lid and flatten the rubber insert, and retighten the lid. The soft
water container is reusable by being immersed in salt water for at least 6 hours after a month's use, so
its softening function will be effectively regained. Replace with a new soft water container every six
months to achieve the best water softening performance.
C
Note: Don't start the machine when there is no water in the reservoir.
11 / 20 EN
Ultrasonic Humidifier / User Manual