Re-Assembling After Activation - Helite HELD Manuel D'utilisation

6. Re-assembling after activation

Before re-assembling check for any external damage and have a new cartridge ready to be
screwed in. If you are unsure of the correct procedure to reset your airbag we recommend you
take it to an authorised dealer for resetting. The vest can be reused if it is reset according to
the following procedure, but if it is not reset correctly there could be malfunctions. You can
also check out our resetting videos online.
Cartridge
USER GUIDE
SCHEME:
A. Position of the trigger after the activation: the
ball is out of its set, the piston has slid towards the
cartridge and the spring is visible.
B. Unscrew the CO2 cartridge and remove it. This
canister may not be reused and must be replaced
with a new one.
C. Unlock the cap with the 5mm allen wrench
supplied with the airbag. You can use your fingers
at some point. Do not unscrew the bearing cap
completely. 12mm out of the cylinder is enough.
Key-Ball
Piston Spring Cap
9