Helite HELD Manuel D'utilisation page 10

10
USER GUIDE
(1)
E. Place the ball bearing back in the recess. Make
sure the ring around the ball bearing is inserted into
the recess of the silver piston and is flush.
F. While ensuring that the ball bearing remains flat
in its set, begin to tighten the cap manually.
G. Finish tightening the cap with the 5mm allen
wrench. The end cap must be tightened until no
thread is showing and the cap will turn no more.
H. Now insert your new CO2 cartridge ensuring that
it is screwed fully by hand so that thread doesn't
shows. Don't not over tighten. The cartridge must
be practically in contact with the plastic of the
trigger. If not tight enough and the cartridge will
not be fully pierced, inducing slow or no inflation.
D. Place the piston back to its
location with your finger or with
the allen wrench through the
cartridge hole. Be careful not to
damage the piston's needle.
(2)