Interactive Module Dimensions; Positioning The Interactive Module; Supported Image Sizes - Epson BrightLink Solo Guide D'installation Rapide

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Interactive Module Dimensions

3.5 in.
(88 mm)

Positioning the Interactive Module

The interactive module mounts on a wall and works with images projected on a pre-installed whiteboard or
directly on the wall. For interactive use, your images must be projected on a hard surface, rather than a
screen.
Note
If you normally project on a screen, you need to move or retract it so that you can project directly on a wall or pre-
installed whiteboard; this may require refocusing your projector.
The projected image must be between 58 and 102 inches (147 and 259 cm), measured diagonally. You may
need to adjust your image size (using your projector's zoom feature) to work with the interactive module. If
you project on a whiteboard, the image may not fill the entire board, depending on the size and aspect
ratio.

Supported Image Sizes

Width and Height Measurements
Width:
from 50.4 to 81.6 inches (1280 to 2073 mm)
Height:
from 28.4 to 61.2 inches (722 to 1555 mm)
Diagonal Measurements
16:10 WXGA:
from 60 to 96 inches (152 to 244 cm) diagonal
4:3 XGA:
from 63 to 102 inches (160 to 259 cm) diagonal
16:9 Widescreen:
from 58 to 93 inches (147 to 236 cm) diagonal
Height of image
area (H)
from 28.4 to 61.2 in.
(722 to 1555 mm)
Width of image area (W) from 50.4 to 81.6 in. (1280 to 2073 mm)
41.4 in. (1051 mm)
58 inches (147 cm)
minimum diagonal
image size (16:9)
5
102 inches (259 cm)
maximum diagonal
image size (XGA)

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Elpiu01

Table des Matières