Installing The Interactive Module; Installing The Wall Plate - Epson BrightLink Solo Guide D'installation Rapide

Installing the Interactive Module

Make sure you follow the steps in this section to install the wall plate, mount the interactive module, attach
the cover, and center the interactive module.
Caution
Make sure you use the appropriate hardware to support the combined weight of the interactive module and wall
plate (approximately 5.08 lb/2.3 kg).

Installing the Wall Plate

You can use either the short wall plate (single-stud) or the long wall plate (double-stud), depending on the
requirements of your building. The illustrations in this section show the long wall plate (double-stud).
If you use the short wall plate, make sure you center it horizontally above the projection area. If you use the
long wall plate, you can adjust the horizontal position after installation, as shown below.
1 Confirm the required distance between the top of the image area and the bottom of the wall plate (
Make a line on the wall at this location above the whiteboard or projection area.
Distance from the top of the projection
surface to the bottom of the wall plate (
Top of the projection surface
2
Determine the location of the studs within the wall. Align the wall plate with the line on the wall and
make sure the holes (either
mounting holes on the wall.
3 Drill holes in the wall at the required locations.
4 Using commercially available anchors or lag bolts, mount the wall plate on the wall.
b
)
or ) in the wall plate align with the studs. Mark the position of the
A B
13
).
b