Assembly And Disassembly Of The System; Assembling The Cleaning Tool; Connecting The Rods; Disconnecting - Wohler Snap & Sweep Mode D'emploi

6

Assembly and disassembly of the system

6.1 Assembling the
cleaning tool
Fig. 12: Assembling the cleaning tool
6.2

Connecting the rods

Fig. 13: Connecting the rods
6.3

Disconnecting

Assembly and disassembly of the system
Slide the male connector of the cleaning tool
•
into the female connector of the rod.
WARNING!
The tabs of the plug must be inserted into the
holes of the sleeve until they engage with a clearly
audible click.
Connect the rods in the same way.
•
• Press the snap straps inwards with the fingers
and thumb of your left hand and simultane-
ously pull the rod or cleaning tool out of the fe-
male connector with your right hand.
EN
29