Rbmp1 Standard Card - Description - CAME PS Série Manuel D'installation

RBMP1 standard card – description
1
2
13
3
4
5
6*
1 - Line fuse 315mA
2 - Circuit protection fuse 630mA
3 - Not used
4 - Not used
5 - Terminal for connecting up the battery and battery
charger (BN1 optional)
6 - Power source terminal * board
7 - Terminals for connecting devices to be managed (i.e.
automation devices, alarms, traffi c lights, etc.)
The minimum, double insulated, cable section, depends on the characteristics and dimensions of the system, and must
not be less than 2.5 mm². Before connecting up the device, cut off the mains power supply.
* Make sure you have a proper omnipolar cut off device, with more than 3mm distance between the power
Hardware and wiring
PS BARCODE -
sectioned-contacts
3
7
8 - Terminal for connecting the PC50
9 - Terminal for connecting the PSE/PSU units
10 - Terminals for connecting incoming digital devices
11 - Warning LED light for "circuit on" and "communication
underway"
12 - Modem connection (or PSI16 if used)
13 - 5-way DIP Switch (for function detailed on page 45)
9
12
11
10
9
8