Operating Accessory Tools (Optional); Adjusting Brush Height; Draining Tanks; Draining Recovery Tank - Nobles POWER EAGLE 716 Manuel Opérateur

OPERATION
5. After cleaning, perform the daily maintenance
procedures.
NOTE: Allow up to one hour for carpet to dry. Use air
movers to reduce drying time.

OPERATING ACCESSORY TOOLS (OPTIONAL)

1. Disconnect vacuum hose from recovery tank
dome and connect accessory vacuum hose
(Figure 7).
2. Connect accessory solution hose to quick coupler,
located at rear of machine (Figure 7).
FIG. 7
3. Attach desired accessory tool to hoses.
4. Turn on Master switch.
5. Begin operating accessory tool (Figure 8).
FIG. 8
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
NOTE: When cleaning upholstery, always check
cleaning instructions sewn in furniture by
manufacturer.
6. After operating accessory tool, relieve water
pressure from tool before disconnecting hose.
Squeeze trigger for five seconds after turning off
switches.
10
Home Find... Go To..

ADJUSTING BRUSH HEIGHT

1. Turn off machine and unplug power cord from wall
outlet.
WARNING: Electrical Hazard. Unplug power
Cord Before Servicing Machine.
WARNING: Spinning Brush. Keep Hands
Away. Turn Off Power Before Working On
Machine.
2. Adjust brush to proper height. Turn height
adjustment knob until bristles slightly touch carpet,
then turn knob another half turn. Turn knob
clockwise to raise and counterclockwise to lower
(Figure 9).
FIG. 9

DRAINING TANKS

WARNING: Electrical Hazard. Unplug power
Cord Before Servicing Machine.
NOTE: Use different buckets to fill and drain machine
to prevent solution system clogs.

DRAINING RECOVERY TANK

1. When solution tank runs dry, recovery tank must
be emptied. To empty recovery tank, turn off
machine and position a discharge bucket under
drain valve down spout.
NOTE: Use different buckets to fill and drain machine
to prevent solution system clogs.
Power Eaglet 716 (08- -05)