Maintenance; Troubleshooting - no!no! Hair 8800 Notice Et Mode D'emploi

Maintenance

Do not use any liquids of any kind to clean the Thermicon™ Tip
or rollers.
Thermicon™ Tips
It is important to keep the Thermicon™ Tip free of hair debris.
Allowing hair to build up may cause it to burn out prematurely
or malfunction. Check and clean the tip periodically during
each treatment session.
To clean the Thermicon™ Tip:
1. Turn off your no!no!
2.
Remove the Thermicon™ Tip.
3.
Gently brush clean.

Troubleshooting

If no!no! does not start when you glide it on the skin:
•
Press and hold the On/Off button down for a few seconds
again until the Status Screen appears.
•
If it's not turning on make sure the unit is charged.
•
Check the Status Screen while gliding. If no bars appear,
replace the Thermicon™ Tip.
•
Make sure the Thermicon™ Tip is not bent or torn. Replace it
if necessary.
Rollers
Although not necessary to the performance of no!no!, keeping
the rollers clean is all part of proper maintenance and will
help the tips last longer. Use the cleaning brush to remove
excess hair and debris from the rollers.
Brush debris out and away from the socket in order to prevent
any particles from falling into the socket.
If any hair or debris fall into the
socket, this may cause no!no! to not
function properly. Gently blow any
particles out of the socket before
beginning the next treatment
•
If the signal light turns red while you glide no!no! on your skin:
•
Check if you are gliding properly.
•
Simply restart your no!no!
•
Check if you need to replace the Thermicon™ Tip.
If the device is not working properly, contact your point of
purchase for examination or repair. The no!no! warranty is
only valid if no!no! has been used according to the instructions
in this guide. Retain all receipts and original packaging.
12