Hahnel CAPTUR Module - Timer Mode D'emploi page 8

steady red
d. DCM is complete. Turn both Timer, Receiver and Transmitter
'OFF' and 'ON' to reboot
Note: For multiple Receivers repeat step 'c' for all receivers without
turning off transmitter
Manual Remote Control
The
Release Button
release. ½ push = Autofocus, LED
Full push = Shutter release, LED
the shutter release for bulb photography, press down
Release Button
flash red. Press
Interval Timer Programmable Functions
Press
Start/Stop
Photography'. The Captur Module - Timer will now take a
photo continuously at the factory set interval time. Press
Start/Stop
The values of the following parameters can be adjusted as
required. Use
the parameters which need to be adjusted. Press SET button
to adjusted parameters.
14
to adjust the value of the parameters. Press SET button
again to confirm adjustment.
Parameters
3
4
5
6
7
6
works similarly to the camera shutter
for more than 3 seconds and LED
Release Button
button to 'Start' the 'Interval Timed
again to 'Stop' the interval timed photography.
Toggle Button
Description
Delay before 1st shutter
is released
Burst/Bulb time
1st Interval Time
= Number of
shots for 1st Interval
= Number of
times program is
repeated
2nd Interval Time
shows steady green.
13
shows red. To 'HOLD'
13
again to release the hold.
< or > to move between
15
Toggle Button
Setting
0s to max 99hrs 59'min
59"s (in 1s increments)
1s to max 99hrs 59'min
59"s (in 1s increments)
1 to 999 and ---
(unlimited)
1s to max 99hrs 59'min
59"s (in 1s increments)
will
13
+ or - is used
15
14
Captur Module - Timer