Operating Tips - Worx HYDROSHOT WP650 Mode D'emploi

Attaching the shoulder strap (only for
WP651)
Attaching the 5L tank to the sprayer (only
for WP651)
NOTE: After the hose is attached, check
the connection by gently pulling upon the
hose. It should not be pulled off.
Starting
Press the lock-off button, then pull the
trigger to begin operation.
NOTE: At the first use or after long-term
storage, remove the spray nozzle and
short lance kit or extension lance first. It is
recommended to pour water directly into
the hose adapter with the machine turned
on to empty the air. Ensure water sprays
out before working.
Spraying
WARNING:
Spray away from body. Wear
proper protective equipment, including
mask and protective eyewear. Do not spray
on windy days.

OPERATING TIPS:

Before usage, follow these tips carefully. Failure to do so
will cause serious personal damage.
1. WARNING: Do not use self-heating, alcohol-based
10
chemicals, hydrogen peroxide, strong caustic chemicals
or strong acids in the sprayer.
2. Do not combine chemicals.
3. Spray area must be well ventilated.
4. WARNING: To reduce the risk of fire or explosion, never
use a liquid with a flash point less than 131°F (55°C). Know
the contents of the chemical being sprayed. Read all
product labels provided with the chemical and follow the
manufacturer's safety instructions.
5. CAUTION: To reduce the risk of electric shock, do not
touch the nozzle during use.
6. WARNING: Never point the spray end at yourself or
others. Keep all body parts out of spray pattern.
7. Never point sprayer in the direction of people or animals.
Always spray in a downwind direction.
8. CAUTION: Avoid spraying on windy days. Mist can be
accidentally blown onto plants or objects that should not
be sprayed.
9. Do not use the sprayer under the extremely high
temperature. Excessive heat may evaporate the mist
before it settles.
10. WARNING: Never smoke, eat, or drink while operating
the sprayer.
11. Do not leave residue in the tank after usage. Clean after
each use.
12. Before working, wait for about 10 senconds after
turned on.
20V Sanitizing pressure washer
See Fig. G1
See Fig. G2
( See Fig. H1)
See Fig. H1,
H2
See Fig. I1, I2
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Inspect the product for damaged or worn parts before
each use. Do not operate it if you find damaged or worn
parts. Contact your supplier or the manufacturer for
replacement parts.
Filter screen maintenance
Remove the hose adapter to get the filter screen. (See Fig.
J1, J2) Rinse it with clean water before reassembling.
NOTE: When retightening the hose adapter, please tighten
securely. Otherwise, it may not draw any water for proper
operation.
WARNING: Any other servicing should be
performed by an authorized service
representative.
CLEANING/STORAGE
Clean thoroughly after each use. Run clean water through
the sprayer to clear spray residue from the body of the
sprayer. Do not store chemicals in the tank. Always store
and dispose of chemicals properly. Before storage,
completely drain all the water from the machine and hose.
Never use flammable chemicals or abrasive cleaning
agents to clean the tank.
Avoid using solvents when cleaning plastic parts. Clean the
moulded plastic housing of the machine using a soft brush
and clean cloth. Do not use water, solvents or polishes.
Store in a secure and dry place out of the reach of children.
Do not place other objects on the product.
Allow all pieces to completely dry before reinstalling
parts and storing the unit. Store the machine and the
accessories in a frost free place.
upright position.
Store the sprayer in an
EN