Victron energy MultiPlus 24/5000/120 Manuel page 156

Masquer les pouces Voir aussi pour MultiPlus 24/5000/120:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 51
APPENDIX E:
ANNEXE E :
APÉNDICE E:
APPENDIX E:
Charge current
120%
100%
80%
Amps
60%
40%
20%
0%
Volts
Charge voltage
16
15
14
13
12
11
10
EN
4-stage charging:
Bulk
Entered when charger is started. Constant current is applied until nominal battery voltage is reached, depending on temperature and input voltage, after which
constant power is applied up to the point where excessive gassing is starting (14.4V resp. 28.8V, temperature compensated).
Battery Safe
The applied voltage to the battery is raised gradually until the set Absorption voltage is reached. The Battery Safe Mode is part of the calculated absorption time.
Absorption
The absorption period is dependent on the bulk period. The maximum absorption time is the set Maximum Absorption time.
Float
Float voltage is applied to keep the battery fully charged
Storage
After one day of float charge the output voltage is reduced to storage level. This is 13,2V resp. 26,4V (for 12V and 24V charger). This will limit water loss to a
minimum when the battery is stored for the winter season.
After an adjustable time (default = 7 days) the charger will enter Repeated Absorption-mode for an adjustable time (default = one hour) to 'refresh' the battery.
NL
4-fase-lading:
Bulklading
Deze start als de lader wordt ingeschakeld. Een constante stroom wordt toegepast tot de nominale accuspanning is bereikt, afhankelijk van de temperatuur en de
ingangsspanning, waarna een constante stroom wordt toegepast tot er overmatige gasvorming optreedt (14,4 V resp. 28,8 V, temperatuurgecompenseerd).
Battery Safe-modus
De op de accu toegepaste spanning wordt langzaamaan verhoogd tot de ingestelde absorptiespanning is bereikt. De Battery Safe-modus maakt onderdeel uit van
de berekende absorptietijd.
Absorptielading
De absorptieladingstijd hangt af van de bulkladingstijd. De maximale absorptieladingstijd is de ingestelde Maximale absorptietijd.
Druppellading
De druppelladingsspanning wordt toegepast om de accu volledig opgeladen te houden.
Opslaglading
Na een dag druppellading wordt de uitgangsspanning verlaagt tot het opslagladingsniveau. Dit is 13,2 V resp. 26,4 V (voor een 12V- resp. 24V-lader). Hierdoor
wordt het verlies van water tot een minimum beperkt als de accu gedurende de winter is opgeslagen.
Na een aanpasbare tijd (standaard = 7 dagen) start de lader in de Herhaaldelijke absorptie-modus gedurende een aanpasbare tijd (standaard = een uur) om de
accu te 'verversen'.
Charge characteristic
Courbe de charge
Características de carga
Laddningsegenskaper
Time
Time

Publicité

Table des Matières
loading

Table des Matières