Led Indications - Victron energy MultiPlus 800VA 48/800/9 Manuel

3.3 LED Indications

LED off
LED flashes
LED illuminated
Inverter/Charger
Charger only
Note: the MultiPlus will shut down if four abnormal events occur within 30 seconds.
The MultiPlus can be reset by switching to Off and then to On.
On / Off / Charger-only switch = On
The inverter is switched on and supplies power to the load.
On / Off / Charger-only switch = On
The inverter is switched on and supplies power to the load.
Pre alarm: overload, or
battery voltage low, or
inverter temperature high.
On / Off / Charger-only switch = On
The inverter is switched off due to one of the following alarms:
overload, or
battery voltage low, or
inverter temperature high, or
DC ripple voltage too high.
On / Off / Charger-only switch = On
The AC input voltage is switched through and the charger operates in
float mode.
On / Off / Charger-only switch = Charger only
The AC input voltage is switched through and the charger operates in
bulk or absorption mode.
On / Off / Charger-only switch = Charger only
The AC input is switched through and the charger operates in float or
storage mode.
7