Removing And Fitting The Belt Clip; Operation; Switching The Radios On And Off; Volume Control - Dexford PMR700 Mode D'emploi

Note: You can also use rechargeable NiMH batteries. Rechargeable batteries cannot be
charged while in the radios.
1. To release the belt clip, press on the upper tab and slide the belt clip upwards.
2. Then open the compartment by sliding the cover downwards.
3. Now insert the batteries taking care to ensure that the polarity is correct. Incorrect polarity
can damage the unit.
4. Close the battery compartment and re-fix the belt clip.
If the batteries are discharged, you will hear signal tones or it will no longer be possible to
switch the radio on.
3.3

Removing and fitting the belt clip

To release the belt clip, press on the upper tab and slide the belt clip upwards.Slide the belt clip
into the guide from above until it audibly engages.
4

Operation

4.1

Switching the radios on and off

To switch on the radio, hold the On/Off button
The display will show the currently selected channel between 1 and 8.
To switch the radio off, hold the On/Off button
sounds.
4.2

Volume control

The volume of the built-in loudspeaker can be displayed in 8 volume steps using the
buttons. The selected volume will be shown in the display with v1 to v8.
4.3

Channel selection

The radios have 8 different transmission channels, which are approved by the European
Committee for Radio Communications as " Private Mobile Radio" channels, known as PMR for
short.
In order to be able to speak between two radios, both units must be set to the same
channel.
MENU
1. Press the
2. Select the required channel using the
3. Confirm the selection with the PTT talk button on the left-hand side.
24
button once.
- English -
MENU
pressed until a signal tone sounds.
MENU
pressed once more until a signal tone
and buttons.
and