Usb Interface; Mode Button; Repeat Button - Chal-tec 10033254 Mode D'emploi

EN
20
7 FLASH: Press this button to cycle through different screen
effects.
• Moving transverse lights (non-reactive to music)
• Square lights wipe (non-reactive to music)
• Transverse lights wipe (non-reactive to music)
• Diagonal Light wipe (non-reac tive to music)
• Wavy Line (non-reac tive to music)
• Shimmering lights (non-reac tive to music)
• Pulsating bars (reac tive to music)
• Off (no lights)
8

USB INTERFACE:

• Use this socket to connect your pen drive or external disk
to the unit using USB interface.
(Note: Mobile disk memory must be less than 64GB.)
• Connect your device's charge cable here to charge it. USB
charging only functions when the unit power is turned on.
9 SD CARD READER: Use this socket to connect your memory
card to the unit by SD card.
(Note: SD card memory must be less than 64GB.)
10 PREVIOUS BUTTON: Press to move the input to the previous
track in MP3 & BT mode, hold for a few seconds to search
backwards within the current track ( not included BT mode).
11 PLAY/PAUSE BUTTON: Press once to begin playing, Press
again to pause. ( USB priority)
12 NEXT BUTTON: Press to move the input to the next track in
MP3 & BT mode. hold for a few seconds
to search forwards within the current track( not included BT
mode).
13 MODE BUTTON: Press once to change the current access
device of the unit.
(USB interface - SD card reader - BLUE TOOTH) the unit
priority read USB interface, SD card reader
14 REPEAT BUTTON: There are 2 preset repeat modes. Press once
to repeat single, that "REP." will be lit at bottom right corner
of the screen. Press it again and unit will be on repeat all, that
"REP." will be put out.