Uv Bulb Replacement; Power Cord Care; Troubleshooting - Hoover WH10600 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

uv bulb RePlaCeMent

The UV/TiO
feature is activated by a fluorescent bulb
2
inside the Air Purifier. As with all bulbs, this will require
periodic replacement, depending on frequency of use.
To ensure bulb is operational, periodically look at back
of the assembled product for a blue glow through the
grille. Checking in a low light environment or in the
dark will aid in seeing the glow.
To replace the UV bulb:
- Switch off the unit, and unplug it from the
AC outlet.
- Remove the rear grille and filter made with HEPA
Media.
- Remove the TiO
coated screen.
2
- Holding the ceramic end of the UV bulb, turn the
bulb gently until it releases from the socket. The
bulb will release from the top. To avoid injury do not
touch the glass.
- Replace the expired bulb with Hoover Part Number:
440001064.
- Reinstall the TiO
2
with HEPA Media and the rear grille.
NOTE: The TiO
coated screen does not require
2
replacement or cleaning.

PoWeR CoRd CaRe

- Do not rest anything on the power cord.
- Do not place the Air Purifier where people or pets
may trip over or walk on the power cord.
- Do not pick the unit up by the power cord.
- Inspect the power cord before use to ensure the
cord and plug are in a good condition.
If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the
checklist below.
Any other servicing should be done by an authorized service representative.
To reduce risk of personal injury - unplug product before servicing.
PRobleM
The air purifier will not
power on.
The airflow is
reduced.
coated screen, the filter made

3. tRoublesHootinG

WARNING
!
Possible solution
1. Check that the power cord is securely plugged into an AC outlet.
2. Check that the rear grille is securely closed.
3. Check that the unit is on a level surface
1. Check that there is adequate airflow around the unit.
2. Check that the pre-filter is not clogged.
3. Check that the filter made with HEPA Media is not clogged.
2.2
WARNING
!
To avoid injury grasp ceramic ends of bulb and
do not touch the glass.
The ultra violet bulb in this product contains
mercury. Dispose according to Local, State or
Federal Laws. For information please refer to www.
lamprecycle.com
!
7
!

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wh10200

Table des Matières