Yamaha PDM-1 Mode D'emploi page 9

Connections
AC cord connection (see page 14)
– Cable fixing bands
Secure any excess cables with bands as required.
Pass the attached cable
fixing band through the
clip as shown in the figure.
1
To tighten:
Pull
To secure cables connected to Terminals, wrap the
cable fixing band around them then pass the pointed
end through the locking block, as shown in the figure.
While ensuring there is sufficient slack in cables
to minimize stress (especially in the power cord),
firmly bind all cables with the supplied fixing band.
2
To loosen:
Push
the catch
From EXIT monitor terminal
on Computer (see page 10)
Pull
AUDIO
PC IN SERIAL
From SERIAL Terminal on
Computer (see page 12)
9