Table des Matières
Publicité
Description
Display symbols:
Camber display
Request for value recording
Caster / KPI
Angle value display:
Upper line: Caster / Lower line: KPI
Angle for max. turn (max. steering angle)
Button assignment
ON/
On / Off button
OFF
Switch on background lighting for 30 seconds.
Light
Switches between the camber measurements, caster / KPI and max. steering. The first mode
is the camber measurement, where the result of the angle is directly shown. In caster / KPI
mode, LED's light signals confirm the recorded angle changes and after the procedure has
ended the display automatically switches to the display values for caster (upper line) and KPI
(lower line).The third mode is for calculating the max. steering angle. Press the button again
to switch back to the camber display.
Press this button to adjust the angle measurement to an inclined plane. The angles in both
measuring directions are thus adjusted to zero. This operating state is indicated by a symbol in
Tara
the bottom right-hand corner. Press this button again to switch back to display of the absolute
angle.
Press this button to "freeze" the angles in the display. This operating state is indicated by a
Hold/
symbol in the bottom left-hand corner. If the button is pressed again the display switches back
Save
to continuous display of the measured values.
Electronic Inclinometer
Manual
LED indicator light
Illuminated LC display
On / Off switch
Display lighting
Switches between the
angle measurements
Keep angle values in the
display
For angle measurement
in an inclined plane.
5
Publicité
Table des Matières
