To Remove A Shelf; Electrical Connection - Caso WineSafe 43 Mode D'emploi

13.5.5

To remove a shelf

13.6 Electrical connection

caso Wine Safe
Remove all bottles from the shelves. Lift the shelf upwards and
the gently pull it out.
► Ensure that the tabs are firmly engaged in place before
storing any bottles.
► Any of the wine shelves can be removed to accommodate
larger bottles.
► Spread your bottles out as evenly as possible over the
shelves, so weight is not concentrated in one point; and
make sure your bottles will not touch the back of the cabinet.
In order to ensure the safe and trouble-free operation of the
device, the following instructions must be observed for the
electrical connection:
• Before connecting the device, compare the connection data
(voltage and frequency) on the rating plate with those of your
electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified
electrician.
• The electrical outlet must be protected by a 16A safety cut-out
switch.
• The connection between the device and the electrical network
may employ a 3 meter long (max.) extension cable with a cross-
section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with
this.
• Make sure that the power cable is undamaged and has not
been installed under or over hot or sharp surfaces.
• This unit is not designed to be installed in an RV or used with
an inverter.
• The electrical safety of the device is only guaranteed if the
device is connected to a properly installed protective conductor
system. Operations using an electrical outlet without a
protective conductor are prohibited. If in doubt, have the house
installation checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages
that are caused by a missing or damaged protective conductor.
Please note
Commissioning
41