Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.2
Instrument adjustment
Unimes
During production, the UNIMES universal mechanical level gauge is
set to its maximum useful measuring range, correspon-ding to a tank
with a height or diameter of 200 cm.
•
To adjust the gauge to the size of the tank, proceed as follows
(see diagramm below).
Fig. 4: Instrument Adjustment
1.
Pull out a length of float line corresponding to the height of the
tank plus the projection of the manhole or flange nozzle, if appli-
cable. Measure the lenght of the lower end to the bottom of the
G2 thread.
2.
Turn the adjustment screw to the right to set the pointer to zero.
The UNIMES gauge is now correctly set for the size of the tank.
– English –
9
Publicité
Table des Matières
