Using The Unit; Starting-Up The Unit; Cleaning And Maintenance - Floorpul W1 Mode D'emploi

USING THE UNIT

Starting-up the unit

- Insert the plug (18 Fig.12) into the sock-
et.
- Press the "I" on the switch (19 Fig.13)
and this will light up.
NOTE:
You can adjust the suction force by sliding
the selector (20 Fig.14) found on the ergo-
nomic handle (10 Fig.14).
The suction force is decreased by opening
the window (21 Fig.14).
Turning the unit off
- Press the switch (19 Fig.13) to turn the
unit off and the light will also go off.
- Remove the plug (18 Fig.12) from the
socket.
CLEANING AND
MAINTENANCE
HAZARD:
The plug must be removed from the sock-
et before any maintenance procedure is
implemented.
Remove the dust bag paper filter and
replace it
- Release the lever (1 Fig.1) and remove
the cover (2 Fig.2) together with the pa-
per bag (3 Fig.2).
- Remove the paper bag (3 Fig.2) from the
cover (2 Fig.2), lift the flap (22 Fig.15)
and fold it into the hole (23 Fig.15), block-
ing it onto the rubber edge, then throw it
away.
- Replace the paper bag and remount all
the parts by following the reverse proce-
dure of the dismantling process.
Checking and cleaning the cloth filter
- Release the lever (1 Fig.1) and remove
the cover (2 Fig.2) together with the pa-
per bag (3 Fig.2).
- Remove the cloth filter (4 Fig.4) and clean
it by removing the dust.
NOTE:
The cloth filter (4) can be washed with warm
water and soap, bearing in mind that it must
be completely dry before re-using it.
- Remount all the parts by following the re-
verse procedure of the dismantling proc-
ess.
Checking and cleaning the filter cartridge
- Release the lever (1 Fig.1), remove the
cover (2 Fig.2), the filter bag (3 Fig.2) and
the cloth filter (4 Fig.4).
- Remove the filter (5 Fig. 16) from the
unit.
- Clean the filter from the inside out with
a jet of air. If this is too dirty, it must be
changed.
- Remount all the parts by following the re-
verse procedure of the dismantling proc-
ess.
Checking and cleaning the safety filter
- Release the lever (1 Fig.1), remove the
cover (2 Fig.2), the filter bag (3 Fig.2), the
cloth filter (4 Fig.4) and the filter cartridge
(5 Fig.16).
- Remove the filter (24) and clean it under
running water.
WARNING:
- Ensure that the filter (24) is completely
dry before remounting it.
- Remount all the parts by following the re-
verse procedure of the dismantling proc-
ess.
Cleaning the shoulder straps and belt
- Clean the shoulder straps (13 Fig.11) and
the belt (15 Fig.11) with a cloth dampened
with water or a neutral detergent.
EN - 3
EN