Hansgrohe AXOR Starck 10407 1 Série Instructions De Montage / Mode D'emploi / Garantie page 12

4
1
4 mm
1
2
1
2
3
English
Open the stops using a 4 mm Allen wrench (1).
Open the stops (1).
Install the carrier plate (2).
Install the carrier plate screws.
Remove the disk.
Place the handle over the stem (1).
Turn the handle counter-clockwise as far as it will
go (2).
Measure the temperature of the output water (3).
If the valve opens through hot, re-
verse the cartridge. See page 16.
If the max. high temperature is
greater than 120°F adjust the
rotational limit stop. See page 18.
Turn the water off.
Remove the handle (4).