Ermax EM1648 Notice De Montage page 3

1074, Avenue des Carrières – Z.A la Plaine du Caire III
13830 ROQUEFORT LA BEDOULE – FRANCE
www.ermax.fr - E-Mail : accueil@ermax.fr
The assembly of the Ermax undertray involves the original indicators' removal.
Fitting kit
- 6 black screws BHc 5x20
- 2 threaded fasteners Ø5
- 1 aluminium fitting plate
- 1 reflector support SDC03
Fitting instructions
- Enlever la selle passager et la selle conducteur.
- - Remove the passenger and pilot saddles.
- Unscrew the screws that secures the rear shells to remove them (see pohotos 1, 2, 3 and 4).
Pay attention when you remove the rear shells !! Pull straight towards you, on pain of breaking the plastic pins
of the taillight !
Screws to
remove
- Keep the central part of the original undertray and place the 2 threaded fasteners Ø5 to the location indicated on th
photo below:
Original plastic inserts location to replace
Think to bring blinkers.
For a compliant mounting, refer to enclosed instructions.
- 6 plastic washers Ø5
- 1 number plate SUP09 Evo
- 1 plate lighting EDP05
1
Rear shells disassembly directions
Plastic inserts to remove
2
4
Threaded fasteners location Ø5
Update : 04/23/2018
FITTING INSTRUCTIONS
ERMAX UNDERTRAY
ADAPTABLE ON MT07 2018 → ∞
Estimated mounting time : 30 min
3
Screws to remove
EN