Herschel Select XLS Série Instructions D'installation Et D'utilisation page 5

Select XLS
ENGLISH
Ceiling mounting – white panels only. Professional installation required
ceiling
Mounting the panel on the ceiling will generally give
the best heat dispersion in the room and keeps wall
min 200mm
spaces free. Ceiling mounting is only possible with
white (non-glass) panels. Ceiling mounting will
require removal of the plug and professional
installation and should be carried out by a qualified
electrician. Larger panels 800w and upwards may
require two people to install safely.
The Herschel Select XLS White series can be
mounted on the surface of ceilings using the
supplied EASYFIX mount. If recessing heaters into a
plaster ceiling, maintain 200mm clearance around
all sides of the heater and maintain at least 800mm
between adjacent heaters. Objects in front of the
panel must be at least 400mm away and 200 mm
away from the sides. The distance from the sides of
the heater must always be observed. Failure to do
so will cause excess heat to build up behind the
heater and will void the warranty.
Select XLS White panels are also equipped with wire
mounting points on the rear of the heater. These
mounting points can be used instead of the EASYFIX
bracket where suspended ceiling mounting is
required (e.g. in rooms with high / vaulted ceilings).
Each mounting wire must be capable of supporting
the weight of the panel individually. Suitable
mounting wire kits are an accessory and are not
supplied with the heater. Contact your Herschel
.
dealer for details