Herschel Select XLS Série Instructions D'installation Et D'utilisation page 4

Plug and Play Options – simple wall mounting & portable (white panels only)
The Select XLS White panels come with a factory fitted plug. They can be easily wall mounted close to an electrical
socket or can be freestanding. Both methods require the use of either the XLS controls (either the plug in control T-
PL or battery control T-BT). See controls section.
min 200mm
Wall mounting (DIY installation)
Mount on the wall using the EASYFIX mounting bracket and
simply plug in the heater (only applies to white panels supplied
with a fitted plug).
This is relatively straightforward for a competent DIY person.
The panel will need to be mounted close to an electrical socket
but MUST NOT be mounted immediately below a socket and
no closer than 200mm away from the socket. The SMART-R
box on the rear of the panel should be located at the bottom
of the panel. The panel can be mounted in either landscape or
portrait position (see detailed installation instructions). Be
careful when drilling holes for the EASYFIX mounting bracket to
be clear of electric cables within the walls. If in doubt do not
install and refer to a qualified electrician.
Freestanding / portable use
The Select XLS White panels can be used freestanding or as
portable heaters e.g. for temporary or seasonal heating. For
portable use we strongly recommend the use of Herschel Feet.
These are specially designed to reduce the risk of the heater
falling over and to prevent the bottom of the heater having
direct contact with floor surfaces. Feet are an accessory and
are not supplied with the heater. Contact your dealer or the
Herschel Website for details.
Select XLS Mirrors and Towel Heaters are not suitable for
portable use. They are supplied without plugs and must be wall
mounted and installed by an appropriately qualified
electrician.
min 200mm
Select XLS
ENGLISH