Balboa HA 350 Instructions D'utilisation page 2

Functional description
Press the pneumatic button, and keep the pressure a few seconds to ensure the pump builds up the needed
water pressure, and then let go off the button again. As long as pressure is present, the pump will run until
the next press on the pneumatic button. This will turn it OFF again. If the water pressure drops (or if there is
no water in the system) the pump will stop automatically. If the pump has been stopped automatically, it will
need re-setting before it will function properly again. This is done by shortly pressing the pneumatic button.
Mounting of pump
There are different ways of installing the pump:
HA 350 PUMP 20-35x211 FOR WHIRLPOOL
DRY RUN FUNCTION
1. The easily accessible rubber feet allow quick installation of the pump,
by screwing 4 pcs. of M6 bolts up into the nuts, that are integrated in
the rubber feet.
2. With a mounting plate 20-0400, you simply screw one M10 bolt or a
threaded pole up into the nut that is integrated in the plate, and the
pump is in place.