Belkin G Plus MIMO Manuel De L'utilisateur page 30

Troubleshooting Troubleshooting
Link LED is blinking slowly; I cannot connect to a
wireless network or the Internet.
If your Card appears to be functioning properly, but you cannot
connect to a network or you have a red wireless icon at the
bottom of your screen, the problem may be that there is a
mismatch between the network name (SSID) settings in your
wireless network properties.
Check the SSID settings to see if they match. The SSID is case-sensitive
and the spelling on each computer must be exactly the same in
order for the Card to connect to the wireless router (or access point).
Note: To check the SSID settings or look for an available
network, double-click the Signal Indicator icon to bring up the
"Wireless Networks" screen. Click "Add" if you do not see the
network you are trying to connect to and type in the SSID.
For more information about setting up an SSID, please reference
your router manufacturer's user manual. If issues persist even at
close range, please contact Belkin Technical Support.
Link LED is solid but I cannot connect to the Internet.
If you have a signal but can't get online or obtain an IP address,
the problem may be that there is a mismatch between the
encryption key settings in your computer and wireless router (or
access point).
Check the WEP, WPA, or WPA2 key settings to see if they match.
The key is case-sensitive and the spelling on each computer and
wireless router (or access point) must be exactly the same in
order for the Card to connect to the router. For more information
about encryption, please see "Securing your Wi-Fi Network" on
page 15 of this User Manual.
If issues persist even at close range, please contact Belkin
Technical Support.
28 28