Maintenance; Maintenance Schedule - Husqvarna DE 110S Manuel D'utilisation

4. Attach the Longopac holder to the rear part of the
container (A). Then attach the Longopac holder to
the sides and to the front of the container (B). Push
the Longopac holder up until you hear a solid click.
(Fig. 19)
5. Make sure that the Longopac is sealed. (Fig. 20)
6. Pull the outer layer of the Longopac cassette down.
(Fig. 21)
7. Close the bottom of the Longopac with a cable tie.
(Fig. 22)
To discard a full Longopac bag and
prepare a new Longopac bag
WARNING:
caution, a full Longopac bag can be heavy.
Make sure that the cable ties are closed
correctly before you lift the Longopac bag.
1. Pull out the Longopac bag (A) and attach a cable tie
(B) to close the new Longopac bag. (Fig. 23)
2. Shake down the dust in the used Longopac bag.
3. Attach a cable tie 10 cm/3.9 in. below the first cable
tie to close the used Longopac bag. Cut off the
Longopac bag between the cable ties. (Fig. 24)
Introduction
WARNING:
occur during the troubleshooting, servicing
and maintenance as the operator must be
in the risk area of the product. The operator
must be careful, make a plan and prepare
the work to prevent accidents.
WARNING:
maintenance, make sure that the motor
switch and the pump switch are in the Off
positions. Disconnect the power cord and
remove the pump cable.
WARNING:
electrician do all checks of the electric
components.

Maintenance

Do the filter purge procedure. Refer to
To remove dust particles from the prefil-
ter during operation on page 15 .
16
Lift the Longopac bag with
Maintenance
Product related accidents
Before you do
Only let an approved
Before
each use
X
4. If the remaining part of the Longopac bag cassette
is too small to prepare a new Longopac bag, install
a new Longopac bag cassette. Refer to
new Longopac bag cassette on page 15 .
5. Obey local regulations for disposal of the full
Longopac bag.
To do after completed work
1. Do the filter purge procedure. Refer to
dust particles from the prefilter during operation on
page 15 .
2. Stop the product, refer to
on page 15 or To start and stop DE 110/DE 120 on
page 15 .
3. Discard the Longopac bag. Refer to
Longopac bag and prepare a new Longopac bag on
page 16 .
4. Clean the product. Refer to
page 17 .
5. Prepare the product for transportation. Refer to
move the product long distances on page 21 .
WARNING:
not make a hole in the filter. Risk of dust
dispersion.
WARNING:
obey all local regulations to dispose the
dangerous dust correctly, before and during
maintenance.

Maintenance schedule

The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
Daily Weekly suction is
To install a
To remove
To start and stop DE 110S
To discard a full
To clean the product on
Make sure that you do
Make sure that you
When Each 6
months or months or
low 600 h
1587 - 007 - 24.01.2022
To
Each 12
2000 h