USER INSTRUCTIONS
LIGHT / DIMMER OPERATION
ON:
Press
AM
on at preset level.
OFF:
Press
SETTING:
1. Press
2. To adjust light between 20...100 %
3. To confirm setting either press
NOTE:
The Light works independently of the Pilot flame. If you
want the light on but no flame, press
PROCONTROL APP
NOTICE
Before the app can be used, the Wi-Fi Box must be wired
and plugged into mains power according to ProControl App
Setup diagram (and the App Setup must be completed.
If Thermostatic, Program or Eco Mode
is activated, the corresponding icon and
AM
"
PM
ON
The modes can be operated according
OFF
1 2
to the descriptions on previous pages.
NOTE:
38
button (
displayed). Light is
button ( disappears).
button and hold until flash-
es.
press
or
button.
ton or wait ( displayed).
button.
" is displayed on the Handset.
In Manual Mode "
" is NOT
displayed on the Handset.
THE PUCK
The Puck is a smart control that works in conjunction with the
GV60 / Symax system. Its basic functions include turning the fire
on and off and turning the flame height up and down.
Down / LO
Figure 3: Lay-out 3 Buttons
but-
TECHNICAL DATA
AMBIENT TEMPERATURE RANGE
CSA: The Puck: 32 °F to 131 °F
CE:
The Puck: 0 °C to 55 °C
RADIO FREQUENCY
CSA: 915 MHz for U.S. and for Canada (The Puck, Receiver)
CE:
868 MHz for Europe (The Puck, Receiver)
Power Supply
Handset: 2 x 1.5 V "AAA" (qualitative alkaline recommended)
NOTICE
Wiring of valve and Receiver must be completed before
starting ignition. Failure to do so could damage the
electronics.
NOTICE
The Handsets and Receivers are not interchangeable
with previous electronics.
To avoid damaging the electronics, do NOT use metal tools
to remove the batteries from the Handset / Receiver.
▪
Without using a mains adapter, battery replacement is recom-
mended at the beginning of each heating season.
▪
Old or dead batteries should be removed immediately. If left
in the unit the batteries can overheat, leak, and / or explode.
▪ Do NOT expose batteries (including during storage) to direct
sunlight, excessive heat, � re, moisture, or severe impact. Each
of these conditions can cause the batteries to overheat, leak,
and / or explode.
▪ Batteries must be kept within their recommended temperature
limits (ambient battery temperature range: 32 °F to 131 °F /
0 °C to 55 °C).
▪ New and old batteries and different brands of batteries should
not be used together. Mixing of various batteries can cause
the batteries to overheat, leak, and / or explode.
ON/OFF
Up/ HI