Table des Matières
Publicité
The appliance must be installed by qualified personnel in compliance with current regulations and regulations in place
UK
relative to domestic electrical wiring and plumbing.
The luminaries must be installed in dedicated rooms and must NOT be installed outdoors.
The appliance must be connected correctly to the mains power supply, i.e. to the terminals marked L (line),
N (Neutral) , otherwise correct operation cannot be assured.
ECOLOGICAL NOTES
Upon completion of the installation phase, please remember to dispose of the packaging and assembly
scraps in accordance with standards in e ect in the country where the product will be used.
P
RECAUTIONS
In order to ensure correct installation and maintenance
of the product, the manufacturer recommends careful
attention to the instructions contained in this
manual. Compliance
with safety norms and the
suggestions described in this manual will ensure that
the product functions perfectly and that the manufacturer's
warranty will be fully applicable.
P
-
RE
INSTALLATION CHECKS
Before you start installation it is advisable to:
- check the integrity of the packaging as indicated on the
pack;
- check that the product has not received blows or
been tampered with.
Once the product is installed, the manufacturer cannot
be held liable for any of the damage mentioned above.
I
NSTALLER
A person who is capable of demonstrating to pertinent
authorities that he has the knowledge and skill in the
application of national regulatory requirements concerning
safety, i.e. electricity, water supply, and disposal.
ATTENTION!
Prior to installation, check that the electrical system is
compliant with standards and laws in e ect and that it is
equipped with a magneto-thermal di erential switch with
an adequate breaking capacity and a di erential of 30mA.
Connection must be made in a fixed and permanent
manner, with no intermediate connections, by installing
an adequate omnipolar disconnecting switch with
minimum aperture distance of contacts which allows
complete disconnection in conditions of category III,
outside of zones 0-1-2-3 and protected from water splash-
es (60 cm laterally beyond the side of the tub or at height
of 225 cm from the floor). (fig. 1)
The power cable must be protected inside the wall by a
corrugated tube or by another system that is compliant
with current standards and certified by the CE directive up
to the connector.
I
NSTALLATION
The installer is responsible for the choice of materials and
complying with standards and laws:
- He must not tamper with the electrical parts of the product, he
must
limit
himself
to
connecting
the
components
as
explained
- He must guarantee that the work done will not compromise
the IP protection level of the luminaries components.
-
If the external exible cable or cord of this luminaire is
damaged, it shall be exclusively replaced by the manufacturer
or his service agent or a similar quali ed person in order to
avoid a hazard.
- To connect the unit to the xed lighting is necessary to use
a terminal conforming to EN 60998-2-1.
The terminal must be screw Bipolar (L, N), 1.5 mm ², 230 V ~, IP44;
- In the case of a failure or malfunction he must contact
After-Sales Service who will supply original spare parts.
The manufacturer is not liable if the product is installed on
premises where the structures and systems are not to
standard or for work performed
or unskilled personnel.
The electrical speci cation of the product with the CE
mark and relative rating plate values are given on the
label on back of the product.Under on circum
stances must this label be removed.
Safety distances and clearances
Zone 1
Zone 0
Zone 2
Zone 3
and
installing
in
this manual.
by unqualified
fig.1
8
14/03/14
Publicité
Table des Matières
