Emergency Operation And Maintenance; Inserting The Batteries; Optimizing Performance - Haier Tempo Série Manuel Du Propriétaire

Remote Control Features and Settings
18 . LIGHT Button
Turns on and off the indoor display. To display only set
temperature press LIGHT button 10 times within 5 seconds.
The indoor will beep 3 times when successful. To return to
ambient temperature display press LIGHT 10 times within 5
seconds again. Default is the indoor unit displaying ambient
temperature. The set temperature will only display a for a few
seconds after adjusting it with the remote.

Emergency Operation and Maintenance

Emergency Operation
• Use this operation only when the remote control is defective
or lost.
• When the emergency operation switch is pressed, the unit
beeps once, which indicates the start of this operation.
• The unit will run automatically in the following modes:
** This image only applies
to AW09TE2VHA &
AW12TE2VHA models.
• During emergency operation, it is not possible to change the
temperature or fan speed. It is also not possible to operate
in timer or dry modes.

Inserting the Batteries

1. Remove the battery cover
2. Insert 2 AAA batteries as
illustrated noting battery
polarity
3. Reinstall the battery cover
NOTE:
• The distance from the remote
control to the reciever should
be less than 23 feet with no obstructions.
• If the remote control display is weak or the operating
distance has diminished, the batteries may need to be
replaced.
• Remote control malfunctions can sometimes be corrected
by removing the batteries from the remote for a few
minutes and then reinstalling them.
• Remove the batteries from the remote control if the unit
will not be in use for an extended period of time. If any
segments of the display remain active after battery removal,
press the reset button.
49-5000094 Rev. 4
emergency
operation switch
19 . RESET Button
If the remote control is not functioning properly, use a pen point
or a similar object to depress this button to reset the remote.

Optimizing Performance

Wipe the cabinet using a soft and
Cleaning the Front Cover
1. Open the front cover by pulling it
upward
2. Remove the Filter:
Gently push up on the filter's center
tab until it is released from the
stopper, and remove the filter in a
downward motion.
3. Clean the filter
Use a vacuum cleaner to remove
dust, or wash the filter with water.
After washing, dry the filter
completely.
4. Attach the filter
Attach the filter so that the "FRONT"
label is facing outward. Make sure
that the filter is securly attached
behind the holding tabs. If the filter is
not attached correctly the unit may
not achieve maximum efficiency.
5. Close the front cover.
Check
monthly and
clean if
needed
7