Removing A Full Trash Bag - GE UCG1680 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Getting started
Compacting
To start the compactor:
Turn the knob to ON.
1
Make sure the drawer is fully closed.
2
Lift the foot pedal up to start cycle.
3
The ram travels downward into the drawer, compacting
the trash. At the bottom of the stroke, the ram
automatically reverses direction, retracts out of the
drawer, returns to its starting position, and the compactor
shuts off automatically.
The cycle takes less than 30 seconds. As the trash
drawer fills with trash, cycle time gets progressively
shorter.
NOTES:
few times you load. The compactor drawer should
be about 1/2 full before the compactor can begin to
compress the load.
Glass bottles can make a loud noise when they
break during compaction. This is normal. Also,
bottles in the trash drawer will not always break during
the first cycle. Breaking glass and associated noise
may occur several cycles later, depending on the type
and volume of the trash.
When bottles and cans are compacted, small tears
in the bag may occur. This is normal and in no way
affects the performance of the compactor. Keep the
bag away from your body to prevent injury from sharp
objects that may have pierced the bag.

Removing a Full Trash Bag

Open the drawer by depressing the foot pedal.
1
Remove the top of the bag from the bag retainer
2
buttons. Pull up all four bag cuffs.
49-55111
IMPORTANT:
Do not apply too much force when turning the
knob. The knob should always rotate easily. Forcing
may break the knob and damage the switch.
When emptying waste baskets into the trash
drawer, some items may spill into the compactor
behind the drawer. Items behind the drawer could
prevent it from closing completely and prevent the
compactor from operating. To remove such items from
behind the drawer, open the drawer and remove it to
clean them out. See the Care and Cleaning section.
To stop the compactor:
The compactor may be stopped at any time.
Attempting to open the drawer while the ram is moving
1
will stop the ram. The safety switch will activate.
Close the drawer completely and the ram will travel
2
back to the UP position.
Open the drawer fully and turn the knob to OFF.
3
Push the side door latch down and tilt the drawer
3
side open.
Lift the bag out.
4
7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Ucg1650Ucg1600

Table des Matières