CASO DESIGN NOVEA B4 Mode D'emploi page 29

1. Place Blender motor/base on a dry, level, stable surface.
2. Set jar into place on motor/base.
3. Place the food solids and liquids to be blended into the jar and put the lid on the jar
before blending. Be sure the measuring cup is in place in the middle of the lid.
4. Plug power cord into a standard electrical outlet.
5. Press to turn the blender on. The blue LED will display 0:00 for the timer, and
will flash.
Please note
► The blender will enter stand-by mode after 2 minutes if no button is pressed. To re-
active the blender from stand-by mode, press
Chop / Mix / Liquefy / Smoothie function
1. Rest one hand on top of blender jar with lid securely in place.
2. Press / /
counting up from 0:00.
3. The timer will stop and the blender will turn off at 1 minute.
4. You can press the button again or press
Crush Ice function
1. To crush ice, ALWAYS have liquid in the jar. Start out with 450 ml of liquid, and add
about two hands full of ice cubes.
2. Hold one hand firmly on the lid.
3. Press , the Blender will spin for one second and rest for two seconds.
4. This will repeat 5 times. The blender will then run continuosly for 45 seconds and then
turn off.
5. If more ice is needed, remove the measuring cup in the middle of the lid and add cubes
one at a time through the hole in the lid.
Warning
► DO NOT CRUSH ICE WITHOUT LIQUID. Failure to follow all of the above directions
can result in damage to the blades, jar, blender motor, and possibly result in personal
injury.
Pulse mode (intermittent operation)
The blender has a pulse mode that is controlled by the other speed settings. This means it
operates only by pressing
All other speeds are continuous cycle operation. By pressing
intermittently.
1. To run the blender intermittently (pulse mode) rather than continuously, rest one hand
on top of blender jar with lid securely in place.
2. Press . The button light will illuminate. LED displays 'P'.
3. Then press
button the blender will stop and turn off. Allow blades to coast to a stop.
Caso Blender NOVEA B4
/ . The button will illuminated blue and the timer will begin
and then choosing a speed level (except Single Serve!).
/ / / /
.
at any time to cancel the operation.
, hold it for 2 seconds. When you release the
the device blends
29