ViewSonic IFP5550 Guide De L'utilisateur page 89

10.2.2 LAN Hardware Specification
ViewSonic LFD communication port on the rear side
(1) Connector type: 8P8C RJ45
(2) Pin Assignment
10.2.3 RS232 Communication Setting
- Baud Rate Select:
- Data bits:
- Parity:
- Stop Bits:
10.2.4 LAN Communication Setting
- Type:
- Protocol:
- Port:
- Cross subnet:
- Logon Credentials: No
10.2.5 Command Message Reference
PC sends to LFD command packet followed by "CR". Every time PC sends control
command to Display, the Display shall respond as follows:
1. If the message is received correctly it will send "+" (02Bh) followed by "CR"
(00Dh)
2. If the message is received incorrectly it will send "-" (02Dh) followed by "CR"
(00Dh)
Pin # Signal
1 TX+
2 TX-
3 RX+
4 BI_D3+ For 1G case
5 BI_D3-
6 RX-
7 BI_D4+ For 1G case
8 BI_D4-
frame GND
9600bps (fixed)
8 bits (fixed)
None (fixed)
1(fixed)
Ethernet
TCP/IP
5000 (fixed)
No
80
Remark
Output from Display
Output from Display
Input to Display
For 1G case
Input to Display
For 1G case