Handling And Positioning - CIAT Aquaciat 2 LD Série Mode D'emploi

Handling and positioning

To lift the unit, fix the slings to the handling holes provided for
this purpose.
The dimensional diagram supplied with the unit indicates the
coordinates of the centre of gravity and the position of the
anchor points.
However, the unit can be handled using a fork-lift truck
provided that the necessary precautions are taken to prevent it
from slipping on the forks of the truck.
Attention:
If a fork-lift truck is used, follow the instructions listed on the
labels on the units. Failure to do so may create a tipping hazard
and result in physical injury.
- Fix the slings only to the anchor points provided and indicated
on the unit.
- Use slings of a suitable capacity and follow the lifting
instructions on the diagrams supplied with the unit.
Sizes
80 to 90 V
100 to 150 V
180 to 300 V
350 to 500 V
540 to 700 V
702 to 1100 V
This diagram is provided only as a general
guide. In all cases, it is necessary to refer to
the diagrams affixed to the unit as well as
the documentation supplied with the unit.
LD
Sizes
In
No load
service
80 V 326 331
329 334
90 V
365 370
100 V
367 372
120 V
449 454
150 V
564 570
180 V
570 574
200 V
576 580
240 V
706 712
300 V
1046 1066
350 V
1145 1165
400 V
1183 1203
500 V
1460 1483
540 V
1596 1621
600 V
700 V 1768 1793
702 V 2135 2170
800 V 2175 2210
900 V 2215 2250
1000 V 2255 2290
1100 V 2310 1345
* With the separated hydraulic module, add 197 kg at no load and 397 kg in service.
A
1100
1100
1100
2242
2242
2300
LDC
In
No load No load
service
344 349 369
347 352 372
383 388 407
385 390 409
467 472 492
611 615 611*
614 618 614*
620 624 620*
751 755 751*
1144 1164 1207
1242 1272 1306
1254 1275 1318
1654 1689 1718
1775 1810 1838
1947 1982 2010
2360 2410 2510
2400 2450 2550
2455 2505 2605
2495 2545 2645
2625 2675 2745
- Attention, the centre of gravity is not always located in the
middle of the unit and the strains applied to the slings are not
always identical.
- Lift and position the unit carefully and take care not to tilt it
(max. angle of tilt: 15°) since this could impair its functioning.
- Use textile slings with shackles to avoid damaging the
housing.
- Use a frame designed to adjust the centre of gravity when
removing the slings from the top of the unit.
- Never subject the unit's metal parts (panels, stanchions, front
access doors) to handling strains. Only the frame is designed
for this.
- Safety of handling is ensured only if all these instructions are
respected. Failure to observe these instructions may result in
damage to the equipment and accidents to personnel.
Weight in kg
LDH ILD
In In
No load
service service
474 328 333
477 331 336
562 366 371
564 368 373
647 452 457
615* 611 615
618* 614 618
624* 620 624
755* 756 760
1477 1096 1116
1576 1195 1215
1588 1283 1303
1998 1570 1593
2118 1706 1731
2290 1878 1903
3060 2270 2290
3100 2320 2340
3155 2365 2385
3195 2445 2465
3295 2505 2535
30
ILDC ILDH
In
No load No load
service
346 351 371
349 354 374
384 389 409
386 391 411
470 475 495
648 652 648*
651 655 651*
656 660 656*
789 793 789*
1194 1224 1257
1292 1322 1356
1355 1385 1418
1675 1710 1748
1804 1839 1868
1976 2046 2040
2550 2580 2680
2600 2630 2730
2645 2685 2775
2725 2765 2855
2825 2875 2955
In
service
476
479
564
566
650
652*
655*
660*
793*
1527
1626
1688
2028
2148
2320
3220
3270
3315
3395
3505