PC Locs LocknCharge iQ 10 Sync Charge Station Instructions D'utilisation page 4

iQ 10 Sync Charge Station
Sync and Charge Instructions
Place your devices in the baskets and then place
them into the iQ 10 Sync Charge Station.
Gently pull the device cables through the rubber
grip cable holder and plug the cables in each device.
Neatly bundle the excess device cables inside the
power compartment.
Replace the power compartment lid by sliding it
back into position and pressing down to close lid.
iQ 10 Charging Station
Charge Only Instructions
Connect your device cables to the USB Power
Supply's. NOTE: only use ports 6-10.
Route the cables through the rubber grip cable
holder.
Place your devices in the baskets and then place
them into the iQ 10 Charging Station.
Gently pull the device cables through the rubber
grip cable holder and plug the cables in each device.