Zwilling ENFINIGY POWER BLENDER PRO 53001 Manuel D'utilisation page 28

Fault
Fault
Problem
The appliance switches off,
display shows E2
The appliance switches off,
display shows E3 or E4
The mixed product contains
many ingredient pieces.
The appliance switches off
immediately.
Liquid runs out of the blender
bowl.
28
Possible cause
Very big amounts of ingredients
of very hard consistency block
the blades.
Motor is overheated. Ventila-
tion openings on the lower side
are blocked.
Motor is overheated. The
blender has been strained to
long and to heavily.
The power button was not
pressed and held for long
enough in the multi-function
program.
The mixing speed is too low or
the mixing duration too short if
you have selected the mixing
speed yourself.
The ingredients are not suitable
for the selected automatic
program to be used.
The power button was not
pressed and held in the mul-
ti-function program.
The blender lid, the lid closure
or both parts are not attached
correctly.
The seal of the blender lid is
broken.
The blender bowl is overfilled.
Remedy
Remove the blender bowl, loosen
contents, possibly reduce their
amount (Caution: Risk of injury
with the blades). Reinstall blender
bowl and resume blending.
Unblock ventilation openings, let
appliance cool down for 1 hour
and resume blending.
If necessary reduce the amount of
contents, let appliance cool down
for 1 hour and resume blending.
Press and hold the power button
until the desired consistency is
reached.
If you have selected the mixing
speed yourself, turn the selec-
tor switch further to the right to
increase the mixing speed, or
extend the mixing process until the
desired consistency is reached.
Finish mixing the mixed product
with the multi-function program
until the desired consistency is
achieved.
Press and hold the power button.
Attach the blender lid correctly
and seal it with the lid closure.
The seal must be exchanged by
customer service.
Reduce the number of ingredients
or the quantity.
GB