NEW POL XF81208DG Mode D'emploi page 6

GB
"El programa ha finalizado" + beep beep
The display can be used to monitor the progress of the selected wash program. At the end
of the wash cycle, all the symbols will disappear and the word "END" will appear.
The washing machine is effecting the pre-wash or main wash.
The washing machine is effecting the rinse cycle.
The washing machine is effecting the spin cycle.
DISPLAY AND DURATION OF THE WASH CYCLE:
At each program position selected with knob
(P), the display will indicate the corresponding
spin speed, the wash phase and the cycle
duration time. The time display will reduce as
the cycle progresses to arrive at zero on
completion of the program. At this point, the
word "END" will appear on the display. The
washing can now be removed from the
machine.
N.B. In the cotton programs, the duration of
VOCE: El programa se iniciará al cabo de : 1 hora 2 horas, 3 horas, 4 , 5, 6, 7 ,8, 9, 10, 11,12,13,14, 15,16 horas
* Values may vary according to the model
The washing machine is equipped with a
function that allows the start of the wash to
be delayed for up to a maximum of 16 hours.
Each time button (1) is pressed, the number
of hours from 1 to 16 that the washing machine
will wait until starting the wash cycle is
displayed (e.g. H.3 indicates that the wash
VOCE: "Ha iniciado el programa" + (repetir la selección de programa, velocidad, pulsadores ) + beep beep
After all the operations described in points 1
to 10 of paragraph "WASH CYCLE" have
been carried out, pressing this button will start
the wash cycle.
VOCE: Ha efectuado un reset + beep-beep ( sonido)
The stop function resets the washing
machine.
If, for any reason, you want to change the
wash program or add more washing to
the load during the wash cycle, simply
place the programmer knob in position
"STOP" (3 lines will flash on the display
and the "START" button light will go out).
Then re-position the knob on the new
program and press the "START" button.
6
EXPLANATION OF DISPLAY SYMBOLS:
the wash cycle is purely indicative, in that
this can depend on a number of factors such
as the temperature and pressure of the feed
water and the quantity of washing loaded in
the drum. During the wash, the machine's
electronics will automatically modify the time
necessary to complete the selected wash
on the basis on these factors. This will
produce the best wash performance in the
shortest time period.
DELAYED START:
cycle will start in three hours' time). After
pressing button (7) the washing machine will
automatically start the wash cycle after the
preset delay period.
START BUTTON:
When the button is pressed, it will light up
after approximately 2 -3 seconds to indicate
that the wash program has star ted.
"STOP" ON PROGRAMMER:
Warning!! only use this function if
strictly necessary and then only if
the program to reset has not been
running for more than 3 minutes.
Before opening the door after a
reset, wait 2 minutes for the
locking mechanism to release.
h. m.
h. m.
h. m.
5 6 7
STOP
stop
Centrifugado
90°
Acl a r a do
75°
En frío 60°
40°
40°
Cotidiano
35°
30°
Rápido
30°
60°
A mano
40°
30°
30°
40°
40°
30°
SM1791