Getting To Know Your Camera - LEXIBOOK DJ040 Série Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Please refer to images A & B (front view, back view and bottom view).

1. Flash

2. Camera lens

3. LED

5. Shutter/confirmation button

6. Power/Menu button

7. Playback mode button

1. Make sure the camera is off.

2. Open the battery compartment by sliding the

battery door in the direction of the arrow.

3. Insert 3 x LR03/AAA 1,5V type batteries

included) observing the polarity indicated at the

bottom of the battery compartment, and as per the

diagram shown opposite.

4. Close the battery compartment.

Note: When the "low battery" icon

the batteries.

Non-rechargeable batteries are not to be recharged. Rechargeable

batteries are to be removed from the product before being charged.

Rechargeable batteries are only to be charged under adult supervision.

Different types of batteries or new and used batteries are not to be

mixed. Only batteries of the same or equivalent type as recommended

are to be used. Batteries are to be inserted with the correct polarity.

Exhausted batteries are to be removed from the product. The supply

terminals are not to be short circuited. Do not throw batteries into a fire.

Remove the batteries if you are not going to use the product for a long

period of time.

WARNING: Mal-function or loss of memory may be caused by strong

frequency interference or electrostatic discharge. Should any abnormal

function occur, remove the batteries and insert them again.

Important note: all files stored into the unit's internal memory will be lost

when switching off the camera or replacing the batteries. Make sure you

transfer the files to your computer before turning off the product or changing

the batteries.

DJ040seriesIM0119.indd 14