Step 2 - Select Screws, Washers, And Spacers - Dynex DX-DTVMFP23 Guide D'installation

STEP 2 - Select screws, washers, and spacers

Select the hardware for your TV (screws, washers, and spacers). A limited number of
1
TVs come with mounting hardware included. (If there are screws that came with
your TV, they are almost always in the holes on the back of your TV.) If you don't
know the correct length of the mounting screws your TV requires, test various sizes
by hand-threading the screws.
Select one of the following types of screws:
For a TV with a flat back:
• M4 × 12 mm screws (E)
• M6 × 12 mm screws (J)
• M8 × 16 mm screws (L)
• M8 × 20 mm screws (M)
For a TV with an irregular/obstructed back:
• M4 × 35 mm screws (F)
• M6 × 35 mm screws (K)
• M8 × 36 mm screws (N)
If you use M4 screws, select the M4 washer (G) or if you use M6 or M8 screws, select
the M6/M8 washer (H). For an irregular or obstructed TV back, also use the
spacers (I).
CAUTION: To avoid potential personal injuries and property damage, make sure that there are
adequate threads to secure the brackets to your TV. If you encounter resistance, stop
immediately and contact customer service. Use the shortest screw and spacer combination to
accommodate your TV. Using hardware that is too long may damage your TV. However, using a
screw that is too short may cause your TV to fall from the mount.
Screw fits
correctly
Remove the screws from the holes in the back of your TV.
2
8 www.dynexproducts.com
Screw is
too long
Screw is
too short