Section 6. Maintenance Instructions; Daily; Monthly - Zodiac Pool Systems Jandy AquaPure Ei Série Mode D'emploi

Page 24
Section 6. Maintenance Instructions
Before servicing the Jandy
the Important Safety Instructions section.
Important: Always test the chlorine levels of your pool before each use.

6.1 Daily

1. Chlorine Test. Test pool water chlorine level with a reliable test kit. Maintain ideal range by adjusting the
chlorine output level on the power pack (see Section 5.3). Recommended free chlorine level is 1 - 3 ppm.
NOTE It is recommended that chlorine test samples be taken from two (2) places, one (1) at the pool return line,
the other well away from the pool return line. Compare the two (2) samples. A higher level should be found
at the pool return line. The higher level at the pool return line indicates the system is producing
chlorine.
2. pH Level Test. Test the pH level of your pool with a test kit. If necessary, adjust to maintain a pH level of
7.4 - 7.6 (see Section 4.3).
Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal dilution of pool
water with fresh water. A build up of by products can damage the electrolytic cell.
3. Total Alkalinity Test. Test pool water for total alkalinity with a test kit. Take steps necessary to maintain an
alkalinity of 80 - 120 ppm (see Section 4.3).
4. Calcium Hardness. Test pool water for calcium hardness level using test kit or by having a water sample tested
by a pool professional. Adjust as necessary to maintain a calcium hardness of 175 - 400 ppm (see Section 4.3).

6.2 Monthly

1. Check the cell. It is recommended that every month the cell be removed and inspected for scale formation and/or
debris. If cell needs to be cleaned, see Section 6.3 for instructions.
2. Salt Level Test. Use salinity test strips, a TDS/salinity meter, or another reliable method to test the salinity of the
pool water. Once the existing salinity has been established, use Table 1 to determine the amount of salt to add to
reach the desired level. Be conservative when adding salt as it is easier to add more if needed than it is to dilute if
there is too much salt. If the salinity level in the pool is correct and the salt LED does not go out, see Section 7:
Troubleshooting.
3. Pool Water Sample. Take water sample to local pool store for testing.
4. Stabilizer (Cyanuric Acid). Test pool water stabilizer (cyanuric acid) level using a test kit or by having a water
sample tested by a pool professional. Maintain ideal range of 10 - 50 ppm. Follow your pool professional's
recommendations. For indoor pools, it is not necessary to add chlorine stabilizer to the swimming pool water.
5. Metals Test. It is recommended that the pool water be tested periodically for the presence of metals such as iron,
and manganese. These metals should not be present in the pool water. If those metals are present, contact your
local pool professional.
AquaPure Ei chlorine generating device please ensure you have read and understood
® ®
TM
CAUTION