Ega Master ROSCAMATIC 80-3 Manuel D'instructions page 11

D6- The die head will automatically open the dies when the threading length is the selected by the
dial threading length.
D7- Stop the machine.
D8- Retract carriage to the initial position.
D1
D5
E) CUTTING
E1- Raise reamer and die head out of the pipe.
E2- Lower the cutter to work position and by turning cutter handle open up cutter guide wider than
the width of the pipe.
Move carriage to position where pipe is to be cut.
E3- Cut the pipe turning the cutter handle in each turn of the pipe until cut is completed. Take care
that the pressure made by the cutting blade isn't excessive. Due to pipe defects it can cause
pipe deformity or bursts in the cutting blade.
E1
D2
D6
CUTTING AND REAMING
E2
D3
D7
E3
D4
D8
11