Guidance And Manufacturer's Declaration - Electromagnetic Emissions - Zero-Plus LND018915V3 Manuel

14. Normative references (Continued)
Guidance and manufacturer's declaration – electromagnetic emissions
The model LND018915V3 is intended for use in the electromagnetic environment specified below.
The customer or the user of the model LND018915V3 should ensure that it is used in such an
environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
portable and mobile RF communications equipment and the LND018915V3
The model LND018915V3 is intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customer or the user of the Model LND018915V3 can help
prevent electromagnetic interference by maintaining a minimum distance between portable and
mobile RF communications equipment (transmitters) and the model LND018915V3 as recommended
below, according to the maximum output power of the communications equipment.
Rated maximum
output
power of transmitter
W
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation
distance d in meters (m) can be estimated using the equation applicable to the frequency of the
transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to
the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
Compliance
The model LND018915V3 uses RF energy only for its
internal function. Therefore, its RF emissions are very
Group 1
low and are not likely to cause any interference in
nearby electronic equipment.
Class B
The model LND018915V3 is suitable for use in all
establishments, including domestic establishments and
Class C
those directly connected to the public low-voltage
power supply network that supplies buildings used for
domestic purposes.
Complies
Recommended separation distances between
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
0.117
0.369
1.167
3.690
11.67
Electromagnetic environment – guidance
m
80 MHz to 800 MHz
0.117
0.369
1.167
3.690
11.67
21
800 MHz to 2,5 GHz
0.233
0.738
2.333
7.377
23.33
Rev: 201605