Zero-Plus LND018915V3 Manuel page 16

Lampe de luminothérapie
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. Installation
1.
Remove the stand from the stand storage cavity.
2.
Insert the end of stand into the hole on the back of appliance.
3.
Place the appliance on a solid surface approximately 20cm from your eyes, the light must
bathe your face from the side.
4.
Connect the appliance only to the mains voltage listed on the type plate.
Note
-
Push the plug completely into the mains socket.
-
Ensure that there is a socket near the place where the appliance will stand.
-
Lay the mains cable in such a way that no one can trip over it.
7. Operation
1. Turning on
Press the ON/OFF button once of the appliance to turn on.
2. Taking the light
You can read, write, make telephone calls or work while you use the appliance. When using the
appliance, try to maintain the recommended distance of 20 cm between your eyes and the
appliance. The duration of the treatment is approx. 2 hours.
Note
-
Do not look directly into the light continuously! Some eye pain or mild headaches may be
experienced during initial sessions but these should pass. If in doubt just lower your
treatment times until comfortable again.
-
Do not leave the appliance unattended in the duration.
3. Enjoying light over longer periods
During the darkest period of the year, repeat the treatment for at least 7 consecutive days, or
longer, depending on your individual requirements.
4. Switching off
Press the ON/OFF button of the appliance to switch off.
8. Cleaning
Warning
-
Before you clean the appliance, always switch it off, unplug it and let it cool off.
-
Do not touch the appliance with wet hands.
-
Clean using a damp cloth, to which you can apply a little detergent if necessary.
-
Do not let water run into the appliance or spill water onto the appliance.
-
Cleaning can be done once per month.
9. Storage
When this appliance is not being used, it should be stored in a dry location out of reach of
children. Do not keep the appliance connected to a power source. Follow the storage instructions
provided in the section "Technical Specification".
10. Disposal
Please note that this appliance is marked with the WEEE symbol on the left.
This means that this appliance must not be disposed of together with ordinary
16

Publicité

Table des Matières
loading

Produits Connexes pour Zero-Plus LND018915V3

Table des Matières