Vivanco UR 44+4 Notice D'emploi

UR 44+4 Universal Controller
(GB) Instructions
UR 44+4 Universal remote control
To control almost all TV sets, satellite receivers, DVD
players and recorders, CD players and other infrared-
controllable devices.
1 Important – please read
The Vivanco UR 44+4 is pre-programmed to control up to 8
devices, replacing damaged or lost original remote controls.
It controls the basic functions of the devices for which it has
been set and is not designed to replace all the functions of
the original remote controls. In order to be able to control
your devices, you must set the remote control as described
in the section "Code entry".
2 Inserting batteries
Open the battery compartment on the underside of the UR
44+4. To do so, lightly press the locking mechanism of the
battery compartment upwards, then insert 2 new AAA
alkaline batteries. Make sure that the polarity is correct: the
"+" and "-" markings on the batteries and in the
compartment must match. To check functionality, press the
PWR button. If everything is correct the red lamp flickers
when the button is pressed.
3 Code entry
The correct control codes can be set via direct code entry or
automatic code search.
Direct code entry
Using the enclosed code list, note the possible codes for the
device and the brand.
To set your TV set, proceed as follows:
1. Using the enclosed code list, find the codes to
control your brand of television (TV). It is
Vivanco GmbH, Ewige Weide 15, D-22926 Ahrensburg, Tel:+49(0)
4102231235, Fax: +49(0)4102 31444, e-Mail: hotline@vivanco.de 1