Important Safety Instructions; About This Manual; Safety; Functions - Samlex Power SMC-10 Manuel Du Propriétaire

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ THESE INSTRUCTIONS COMPLETELY
BEFORE INSTALLATION!

1. ABOUT THIS MANUAL

These operating instructions are part of the product. Read these operating
instructions carefully before use, keep them over the entire lifetime of the
product, and pass them on to any future owner or user of this product.
This manual describes the installation, function, operation and maintenance
of the solar charge controller. These operating instructions are intended for
end customers. A technical expert must be consulted in cases of uncertainty.

2. SAFETY

The SMC-10 solar charge controller may only be used in PV systems for
charging and controlling lead-acid batteries in accordance with this oper-
ating manual and the charging specifications of the battery manufacturer.
The solar charge controller may only be connected to the local loads and
the battery by trained personnel and in accordance with the applicable
regulations. Follow the installation and operating instructions for all com-
ponents of the PV system.
No energy source other than a solar generator may be connected to the
solar charge controller. Follow the general and national safety and accident
prevention regulations.
Keep children away from PV systems. Do not use the solar charge controller
in dusty environments, in the vicinity of solvents or where inflammable
gases and vapours can occur. No open fires, flames or sparks in the vicinity
of the batteries. Ensure that the room is adequately ventilated. Check the
charging process regularly.
Follow the charging instructions of the battery manufacturer. Battery Acid
splashes on skin or clothing should be immediately rinsed with plenty of
water. Seek medical advice. Do not operate the solar charge controller
when it does not appear to function at all, or if the solar charge controller
or connected cables are visibly damaged or loose. In these cases immediate-
ly remove the solar charge controller from the solar modules and battery.

3. FUNCTIONS

The solar charge controller monitors the state of charge of the battery
bank, controls the charging process, controls the connection/disconnection
of loads. This optimises battery use and significantly extends its service life.
SAMLEX AMERICA INC. | 3